Using the Kolver EDU 2AE/TOP/E Driver
  • 30 Sep 2022
  • 1 Minuto para Ler
  • Contribuintes

Using the Kolver EDU 2AE/TOP/E Driver


The content is currently unavailable in Portuguese. You are viewing the default English version.
Resumo do artigo

Using the Kolver EDU 2AE/TOP/E Driver

A guide to the Kolver-EDU-2AE-TOP-E Driver

This article describes the capabilities and configuration associated with the Kolver-EDU-2AE-TOP-E driver in Tulip.

Capabilities

The Kolver-EDU-2AE-TOP-E driver supports bidirectional communication between controller and Tulip.

The driver supports setting programs with one property:

  • Run Program - a number corresponding to a program set on the Kolver.

This output can be used in a Tulip App Trigger as shown below:

The driver reports that a program is complete with one property:

  • Kolver Program Ended -  True if program completed successfully.

This output can be used in a Tulip App Trigger as shown below:

Configuration

In order to use your Kolver controller with Tulip, you will need to build a cable and configure the controller to use it with the Tulip Edge IO or IO Gateway.  For setup information, please see this article. How to Set Up and Use a Kolver Torque Controller

Then, visit the Device Portal page for your Device to turn on the driver.


Este artigo foi útil?