Setting Up an Edge MC
How to set up Edge MC for the first time.
The Edge MC uses the same Device Portal as the Edge IO and I/O Gateway. This article will outline how to connect the device.
Physical Setup

- Locate DC-5V USB power port
- Plug supplied USB power supply
- Plug the other end of the power cable into a power outlet

- Verify red LED turns on and blinks

- Plug Ethernet cable into WAN port
- Plug the other end into an active Ethernet outlet
Next step:
Register your Edge MC to your Tulip account
Edge IO
Edge MC is a Tulip-developed Edge Device. run Node-RED flows on dedicated hardware with built-in security and stability.
Edge Mc can also act as a Connector Host or OPC-UA Broker
Device Portal
The Device Portal is the home where you can configure Light Kits, and Device Drivers, see Edge Device network status, and more.
Edge IO
Edge IO is a Tulip-developed Edge Device. Interface with digital inputs directly from Triggers, flip digital outputs, run Node-RED flows, and more!
Edge IO can also act as a Connector Host or OPC-UA Broker
Was this article helpful?
Thank you for your feedback! Our team will get back to you