This article describes the capabilities and configuration associated with the Kolver-EDU-2AE-TOP-E driver in Tulip.

Capabilities
The Kolver-EDU-2AE-TOP-E driver supports bidirectional communication between controller and Tulip.
The driver supports setting programs with one property:
Run Program - a number corresponding to a program set on the Kolver.
This output can be used in a Tulip App Trigger as shown below:

The driver reports that a program is complete with one property:
Kolver Program Ended - True if program completed successfully.
This output can be used in a Tulip App Trigger as shown below:

Configuration
In order to use your Kolver controller with Tulip, you will need to build a cable and configure the controller to use it with the Tulip Edge IO or IO Gateway. For setup information, please see this article. How to Set Up and Use a Kolver Torque Controller
Then, visit the Device Portal page for your Device to turn on the driver.