This article describes the capabilities and configuration associated with the Omega HH806 Thermometer driver in Tulip.

Capabilities

The Omega HH806 Thermometer driver allows the Omega HH806 series of temperature loggers to be integrated into Tulip apps though the Tulip IoT Gateway. 

Communication is one-directional from the device to Tulip over the Omega 8XX USB wired protocol.

The driver supports sending temperature readings from the device to Tulip. This is exposed in the Tulip App Editor as a "Device Event" as shown below:

WHEN

  • "Device" "Omega HH806" outputs at "this station" with events... (port 1 temperature, port 2 temperature)

The temperature is reported for both thermocouple ports (T1 and T2) in Celsius, Fahrenheit, and Kelvin.

Configuration

To configure your Omega HH806 Thermometer device to be used with Tulip, first ensure that the device is powered and connected to a Tulip Gateway with a mini-USB cable.

Then, visit the Gateway Portal page for your Gateway to configure the driver.

The relevant configuration screen is shown below.

The options are described in detail below:

  • Disable Thermocouple Port 1 - By default, readings are regularly sent from the device to Tulip. Checking the box for this option prevents reporting events from Port 1.
  • Disable Thermocouple Port 2 - By default, readings are regularly sent from the device to Tulip. Checking the box for this option prevents reporting events from Port 2.
Did this answer your question?