Reset I/O Gateway to Factory Settings

Reset I/O Gateway to Factory Settings

This will reset the I/O Gateway to its default configuration by purging:

• Network Configurations
• I/O Gateway Access Credentials
• Tulip Account Authentication
• Driver Configurations
• All I/O Gateway settings, including Light Kit

The I/O Gateway's IP address may also change after a factory reset.

This is the only way to reset your I/O Gateway's Password

Instructions

1. Verify I/O Gateway is not actively controlling any devices
2. Hold down A & B buttons at the same time for 5 seconds
3. Release buttons when blinking light turns off
4. When light turns back on (3-5 minutes), I/O Gateway is reset
5. Set up I/O Gateway.